Make sure you are using a straight through serial/parallel cable. See if flow control is set for hardware or software. Main thing is to make sure set up on the plotter matches the driver, which matches the software. Has little to do with the plotter or other hardware. ![]() Got them from CADALOG.Īll your problems are software related. I have some Xerox plotter drivers, but they are for R-12 and R-13. The Lorand Plotter talk site is done now, but will try to remember what was noted there. ![]() If you had a drawing with just a single line, it may accept it, and draw it, but most of use begin with large drawings and try from there. The Cheksum error message is that your computer is send data too fast to the plotter. Xerox used parts and drivers from (I think) Cannon, then put theirown lable onto everything.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |